JukeBlaster.com Forum

General Category => Coin Kit ccTalk software => General Discussion => Topic started by: xmiker on December 02, 2016, 08:32:39 AM

Title: Connect coin acceptor to software
Post by: xmiker on December 02, 2016, 08:32:39 AM
Hi.
I try trial version of software to connect cctalk coin acceptor to PC. All wires like in scheme. I use USM-COM adapter Prolific PL2303 and Silicon Labs CP210x. In software coin acceptor detected (I try to connect EMP800, NRI G-13, SR3, Microcoin SP). But then software writes: failed to map coin. What does it mean? What can I do to connect coin acceptor to software?
Thanks.
Title: Re: Connect coin acceptor to software
Post by: Steve on December 02, 2016, 05:41:17 PM
Hi xmiker

'Failed to map coin' means the coin acceptor did not reply (timeout).
Can you show some pictures of your wiring to the SR3 ?.

Steve
Title: Re: Connect coin acceptor to software
Post by: xmiker on December 05, 2016, 07:19:07 AM
Hi.
Thank you for your answer.
I think maybe SR3 not in CCTalk protocol? But I try some another coin acceptors: EMP, Microcoin SP.
Title: Re: Connect coin acceptor to software
Post by: Steve on December 05, 2016, 09:09:07 AM
Hi xmiker

Ok, wiring looks correct, 2 things to try...

1. check your comm port is set to 9600 baud rate
2. change usb cable to this one:- http://www.ebay.co.uk/itm/USB-to-RS232-TTL-PL2303HX-ble-Adapter-COM-Module-Converter-Adapter-Arduino-/322099557451?hash=item4afea1344b:g:HPUAAOSwEjFXfqVQ

Steve
Title: Re: Connect coin acceptor to software
Post by: Bry on December 07, 2016, 09:11:50 AM
that rs232 adapter in picture 3 is wrong
it probably has wrong voltage may damage the sr3, it might be giving out 9v wich is too much, u need the prolific PL2303HX which gives 5v (logic level output).
Title: Re: Connect coin acceptor to software
Post by: xmiker on December 07, 2016, 02:13:38 PM
Hi.
Com port - 9600.
My USB-COM is Prolific PL2303HXD.
Is it different from PL2303HX?

Can I connect directly to COM-port without USB converter?
Title: Re: Connect coin acceptor to software
Post by: xmiker on December 08, 2016, 11:02:59 AM
Stupid question ))) I need MAX232 to connect to COM directly.
Title: Re: Connect coin acceptor to software
Post by: Bry on December 08, 2016, 03:36:28 PM
You need USB to TTL (5v), comport is higher voltage
Title: Re: Connect coin acceptor to software
Post by: xmiker on December 09, 2016, 07:37:29 AM
Hi.
Yesterday I tried connect coinacceptor via Circuit 1 - ccTalk Standard Interface (from CCTalk documentation part 3). Coinacceptor EMP800 is working fine.
Title: Re: Connect coin acceptor to software
Post by: Bry on December 09, 2016, 08:42:57 PM
very goo d then maybe that usb lead gives ttl level outputs