Author Topic: Connections  (Read 6464 times)

kaneit

  • Guest
Connections
« on: June 30, 2012, 04:51:30 PM »
How do I connect a C220B coin mech/coin accepter to the Coin-kit board?

A cable diagram would be helpful :-)

Thanks


kaneit

  • Guest
Re: Connections
« Reply #1 on: July 01, 2012, 10:31:08 AM »
What signal does coin input need to be for the coin kit board, 12VDC?

Bry

  • Administrator
  • Sr. Member
  • *****
  • Posts: 377
    • Jukeblaster.com
Re: Connections
« Reply #2 on: July 03, 2012, 05:24:16 PM »
Q. What signal does coin input need to be for the coin kit board, 12VDC?

A. if u put 12v into the coin input you will BLOW-UP your board! :o, read the warning instrushons that come with coinkit, Coin kit accepts either a LOW or OPEN pulse input only



Q. How do I connect a C220B coin mech/coin accepter to the Coin-kit board?

A. Coin kit is not designed for use with a c220b, however u can modify CoinKit at your own risk
put coin kit into ccTalk mode - see here http://jukeblaster.com/forum/index.php?topic=459.0

on the ccTalk connector of ur c220b conect the following-
connect the data pin of the c220b to the coin screwterminal on coin kit
conect the 0v of the c220b to the gnd screwterminal on coinkit
connect 12v pin of c220b to 12v screwterminal on coin kit
u may also need to connect pin9 to gnd (ccTalk enable) read the c220b datasheet, (google it)

put 12v into coinkit 12v jack, see if 220b takes a coin, if it does plug in the usb

done
« Last Edit: July 03, 2012, 09:52:51 PM by Bry »
Send us some crypto :-)
It helps us us pay for the forum and new jukebox developments


Bitcoin
bc1qz9wd2ymdnjy3ge5h7fjlrdc2zt0grry0ugwwv4

Ethereum
0xC3bB19c7078055117f2481ACb81587d6Da343B0E

Doge
DGvvJZ6JNxcGtSSbgjaNE5zDe13YWwaPVE


Bry

  • Administrator
  • Sr. Member
  • *****
  • Posts: 377
    • Jukeblaster.com
Re: Connections
« Reply #3 on: July 03, 2012, 09:48:01 PM »
here is a diagram picture for u, this is for the sr5 but i think the 220b is teh same conector -

Send us some crypto :-)
It helps us us pay for the forum and new jukebox developments


Bitcoin
bc1qz9wd2ymdnjy3ge5h7fjlrdc2zt0grry0ugwwv4

Ethereum
0xC3bB19c7078055117f2481ACb81587d6Da343B0E

Doge
DGvvJZ6JNxcGtSSbgjaNE5zDe13YWwaPVE


kaneit

  • Guest
Re: Connections
« Reply #4 on: July 04, 2012, 12:15:03 AM »
i shall give this a looking at.

thanks again.

kaneit

  • Guest
Re: Connections
« Reply #5 on: July 04, 2012, 12:16:08 AM »
Also Bry in your coin kit installation video....

What is the exactly power supply adapter did you use?

please could you tell me the one you used