JukeBlaster.com Forum

General Category => General Discussion => Topic started by: reno on January 16, 2016, 12:57:31 AM

Title: Mapping Power Button.
Post by: reno on January 16, 2016, 12:57:31 AM

Hey Guys,
             I am looking at moving to Touch Screen All-in-one Pc's for my jukebox set up. With the current computers i am using, I have solder two wires on on/off switch and extended them outside of the computer case and onto a normally open on my jukebox case. (For power on and off the computer)
    With the All-in-One Pc's, opening them it up and solder is not a good idea and will be a very hard task.
So is there a way to map a button that will turn the computer on/off.

Title: Re: Mapping Power Button.
Post by: Steve on January 16, 2016, 08:01:17 AM

The power button is the keyboard 'End' key.
You can use any key interface board to activate the end key but I recommend 'Coin Kit' with remote control, see it here:- http://jukeblaster.com/index.php?page=detail&get_id=4&category=