General Category > General Discussion
Coin Mech Power Dilemma!!
PMiddy001:
Hi Steve,
According to that it's pin 8 for ground. The same as the diagram I uploaded. The table confirms this too. If you look closer, the marker turns diagonally and goes to pin 8.
Steve:
You need BOTH pin 8 & pin9 to gnd, it's pin9 that switches the acceptor from parallel mode to ccTalk mode...
PMiddy001:
Oh wow! I followed that video step by step and I never caught that part. I have some of those wire splicing connectors so I'll splice an extra wire to pin 9. Thank you very much for explaining this, Steve. I'll fetch it back up to the house!
PMiddy001:
Spliced 8 to 9 but still no difference. The green LED is constant until the coinkit software detects which port the coin mech is connected to, at this point the LED starts to blink green to red like in my previous linked video. That's a shame as I had my hopes up for a few minutes.
PMiddy001:
Steve, I'm unable to send private messages for some reason - can you message me so that I can send you something back?
Navigation
[0] Message Index
[*] Previous page
Go to full version