General Category > Wiring-up

Re: Coin Input

<< < (2/2)

Spinny56:

--- Quote from: Bry on February 10, 2012, 08:32:29 PM ---sounds to me like your input is floatin u have to pul the input low or go from low to open coin kit will auto detect this transition
is ur coin kit conected to a credit board and then into a acceptor  I cant tell from ur

 I only have to connect the usb to the coin board  (just the usb lead) nothing else and the credits jump to 99 which is max. I can get into the service menu but not the sub menus unless i remove the usb lead from the board. all this is before i power up the coin board ?? I cannot input my pin number to gain access to the service menu unless i remove the usb lead
if i put my keyboard into the PS2 i can get credits on the f1 & f2 buttons.
I feel the coin board credits are stuck in the open position yet the little black button operates freely
i hope there is no problem if i return the coin board for a check???
--- End quote ---

Bry:
spiny the board was checked before it was sent out by me it is fine
sounds like you may not be folowin the instructions properly to install ur board
if you don have a acceptor and power connected to th board the input wil float u need to connect ur coin mech as per the instructons befor u conet the usb
follow the instructions with ur board or watch the video here http://jukeblaster.com/forum/index.php?topic=380.0

Navigation

[0] Message Index

[*] Previous page