JukeBlaster.com Forum

General Category => Videobox => General Discussion => Topic started by: cheersray on February 16, 2015, 06:15:17 PM

Title: Coin Mech
Post by: cheersray on February 16, 2015, 06:15:17 PM

Hi
have videobox installed works fine
have coin controls c220 coin mech connected to an excel v2 credit board.
how do I get it working with videobox

RAY

Title: Re: Coin Mech
Post by: jukejohn on February 17, 2015, 05:49:05 PM

I set up vjb using the same coin mech and credit board I take it you have a ipac board connected to the excel board
if so you just need to remap the ipac output to f1

Title: Re: Coin Mech
Post by: cheersray on February 18, 2015, 09:27:01 PM

hi john
not quite up to this not really sure what you mean can you translate to idiot
terms for me.

Ray

Title: Re: Coin Mech
Post by: jukejohn on February 21, 2015, 11:19:44 AM

will get back to u soon bogged down with flu so head not clear
in the meantime can you tell me what juke cab this is using or mayb post photos of it so I can see whats involved

Title: Re: Coin Mech
Post by: Bry on February 21, 2015, 03:58:37 PM

the c220 is an realy old mech that dosnt suport modern serial standards and the excel board dos not have the ability to conect to a pc so i would say they are not best suited for the job

i would advise u go with a modern mech like a SR5 (search ebay) and conect it to ur pc with a Coin Kit (either software or hardware version) see here ->

hardware -  http://jukeblaster.com/index.php?page=detail&get_id=4&category=

software -  http://jukeblaster.com/index.php?page=detail&get_id=28&category=

just my 2 cents :-)

Title: Re: Coin Mech
Post by: jukejohn on February 21, 2015, 09:01:27 PM

that's why I suggested a ipac unit connected to the excel board it does work ok did it myself along time ago
however if he as limited knowledge on this subject it would be easier to use your coin kit which is basically plug and play with another coin mech