JukeBlaster.com Forum

General Category => Juke Blaster Pro => Configuration & Installation => Topic started by: forrestf on October 12, 2011, 02:27:28 AM

Title: Coin-Op mode with Matrix usb bill acceptor
Post by: forrestf on October 12, 2011, 02:27:28 AM

Hey guys, I'm new! i am trying to get juke blaster pro working with a matrix usb bill acceptor. it says its a pulse type. the model is VTIUSB-1. not sure what to do. any pointers?

here is a link to the manual

http://www.validationtech.com/sellsheet/matrix%20sell%20150.pdf (http://www.validationtech.com/sellsheet/matrix%20sell%20150.pdf)
http://www.validationtech.com/support/MXUSB_Manual_1.pdf (http://www.validationtech.com/support/MXUSB_Manual_1.pdf)

Title: Re: Coin-Op mode with Matrix usb bill acceptor
Post by: forrestf on October 12, 2011, 02:38:00 AM

also it says it supports usb, cctalk and pulse. I think the problem is that matrix's pulse to usb board might not output the same as the kim board? i might have to remove their usb board. not sure. any tips?

Title: Re: Coin-Op mode with Matrix usb bill acceptor
Post by: Bry on October 12, 2011, 07:54:03 AM

hi dude  from the usb datasheet it looks like its using its own unique language ? so i dont thint taht would work
but it also has ttl & pulse mode outputs that should work throug an interface board like the Kim or our new input board Coin Kit.
post the pulse & ttl datasheet and i will look.

Title: Re: Coin-Op mode with Matrix usb bill acceptor
Post by: forrestf on October 13, 2011, 07:19:16 PM

http://www.validationtech.com/support/VTIOM-3.pdf (http://www.validationtech.com/support/VTIOM-3.pdf)

i think thats it for the model without the usb board of theirs. do you know when i can get one of your boards?

Title: Re: Coin-Op mode with Matrix usb bill acceptor
Post by: Bry on October 15, 2011, 10:21:46 PM

looks like you will need a board with multible inputs like 1 for each note, kim would do it with plenty to spare but new board probably just one chanel for 1 note
edit: